The Direction and Extent of Chemical Change
ΔG determines the direction and extent of chemical change. Remember that ΔG is meaningful only for changes in which the temperature and pressure remain constant. These are the conditions under which most reactions are carried out in the laboratory. The system is usually open to the atmosphere (constant pressure) and the process is started and ended at room temperature (after any heat that has been added or which was liberated by the reaction has dissipated.)
The importance of the Gibbs function can hardly be over-stated: it determines whether a given chemical change is thermodynamically possible. Thus, if the free energy of the reactants is greater than that of the products, the entropy of the world will increase and the reaction takes place spontaneously. Conversely, if the free energy of the products exceeds that of the reactants, the reaction will not take place.
In a spontaneous change, Gibbs energy always decreases and never increases. This of course reflects the fact that the entropy of the world behaves in the exact opposite way (owing to the negative sign in the TΔS term). Here is an example:
Water below zero degrees Celsius undergoes a decrease in its entropy, but the heat released into the surroundings more than compensates for this so the entropy of the world increases, the free energy of the H2O diminishes, and the process proceeds spontaneously.
An important consequence of the one-way downward path of the free energy is that once it reaches its minimum possible value, net change comes to a halt. This, of course, represents the state of chemical equilibrium. These relations are summarized in this table.
Conditions for Spontaneous Change
Recall the condition for spontaneous change:
ΔG = ΔH – TΔS < 0
It is apparent that the temperature dependence of ΔG depends almost entirely on the entropy change associated with the process. (it is appropriate to say "almost" because the values of ΔH and ΔS are themselves slightly temperature dependent; both gradually increase with temperature). In particular, notice that in the above equation the sign of the entropy change determines whether the reaction becomes more or less spontaneous as the temperature is raised.
For any given reaction, the sign of ΔH can also be positive or negative. This means that there are four possibilities for the influence that temperature can have on the spontaneity of a process:
Case 1: ΔH < 0 and ΔS > 0
Under these conditions, both the ΔH and TΔS terms will be negative, so ΔG will be negative regardless of the temperature. An exothermic reaction whose entropy increases will be spontaneous at all temperatures.
Case 2: ΔH < 0 and ΔS < 0
If the reaction is sufficiently exothermic it can force ΔG to be negative only at temperatures below which |TΔS| < |ΔH|.
This means that there is a temperature defined by
Case 3: ΔH > 0 and ΔS > 0
This is the reverse of the previous case; the entropy increase must overcome the handicap of an endothermic process so that TΔS > ΔH.
Since the effect of the temperature is to "magnify" the influence of a positive ΔS, the process will be spontaneous at temperatures above
Case 4: ΔH > 0 and ΔS < 0
With both ΔH and ΔS working against it, this kind of process will not proceed spontaneously at any temperature. Substance A always has a greater number of accessible energy states, and is therefore always the preferred form.